Get 20M+ Full-Text Papers For Less Than $1.50/day. Start a 14-Day Trial for You or Your Team.

Learn More →

Insulation Panels Made from Thermally Modified Bark

Insulation Panels Made from Thermally Modified Bark AbstractThermally treated and ground poplar bark was used as the raw material for pressed bark insulation panels. Bark chips were treated for one, two, and three hours at 180 °C after a slow warming, drying process. The physical and mechanical properties of the pressed panels were investigated and compared to each other and to the control panel made of untreated bark chips. Thermal conductivity showed slight deviations and ranged from 0.064 – 0.067 W·m−1·K−1. The MOR and MOE showed a significant increase of 100%. The internal bond increased by 27% while the water absorption and thickness swelling decreased by 53.8% and 69.1% respectively. Panel density did not change significantly because the target density was the same for every panel type. The mechanical and physical properties of thermal insulation panels made of heat-treated chips increased significantly. http://www.deepdyve.com/assets/images/DeepDyve-Logo-lg.png Acta Silvatica et Lignaria Hungarica de Gruyter

Loading next page...
 
/lp/de-gruyter/insulation-panels-made-from-thermally-modified-bark-qJFQYGWYPw

References

References for this paper are not available at this time. We will be adding them shortly, thank you for your patience.

Publisher
de Gruyter
Copyright
© 2019 Zoltán Pásztory et al., published by Sciendo
ISSN
1787-064X
eISSN
1787-064X
DOI
10.2478/aslh-2019-0002
Publisher site
See Article on Publisher Site

Abstract

AbstractThermally treated and ground poplar bark was used as the raw material for pressed bark insulation panels. Bark chips were treated for one, two, and three hours at 180 °C after a slow warming, drying process. The physical and mechanical properties of the pressed panels were investigated and compared to each other and to the control panel made of untreated bark chips. Thermal conductivity showed slight deviations and ranged from 0.064 – 0.067 W·m−1·K−1. The MOR and MOE showed a significant increase of 100%. The internal bond increased by 27% while the water absorption and thickness swelling decreased by 53.8% and 69.1% respectively. Panel density did not change significantly because the target density was the same for every panel type. The mechanical and physical properties of thermal insulation panels made of heat-treated chips increased significantly.

Journal

Acta Silvatica et Lignaria Hungaricade Gruyter

Published: Jun 1, 2019

There are no references for this article.